Appliance Operations
Use the appliance console for the tasks on this page. The console tabs are Overview, Network, System, and Maintenance. Press 1–4 to switch tabs, the up and down arrows to move, and Enter to select. Press Ctrl+C to leave the console.
Update the cyolo-admin password
Change the cyolo-admin password on the appliance console. This password is used for SSH and TTY2. The Launcher Web UI does not change it.
- Open the appliance console.
- Open the System tab. Press 3, or select 3 System.
- On Admin Password, select Change Password.
Switch between the UI and the terminal
The appliance UI is on TTY1. The terminal is on TTY2.
| Keyboard | Appliance UI (TTY1) | Terminal (TTY2) |
|---|---|---|
| Windows | Ctrl + Alt + F1 | Ctrl + Alt + F2 |
| Mac | fn + control + command + F1 | fn + control + command + F2 |
Open the UI from SSH
SSH to the appliance as cyolo-admin, then run ui. The appliance UI opens in that session.
ssh cyolo-admin@<appliance-ip>
uiNetwork configuration
Change the appliance address from the console Network tab, or add more interfaces from the terminal.
Network tab
- Open the appliance console.
- Open the Network tab. Press 2, or select 2 Network.
- Set the fields under Network Settings:
| Field | What to enter |
|---|---|
| DHCP | Enabled to obtain an address automatically, or Disabled to enter a static address. Press Left or Right to change the selection. |
| Proxy | Optional proxy address for outbound connections, for example http://proxy.example.com:8080. |
| IP Address | Address of this appliance, including the prefix, for example 192.168.64.3/24. |
| Gateway | Default gateway. |
| DNS Servers | Comma-separated DNS servers. |
- Select Apply Changes. Select Cancel to leave the fields unchanged.
Up and Down move between fields. Enter moves to the next field or runs the selected action.
Additional interfaces
Configure interfaces with files in /etc/network/interfaces.d/.
Example /etc/network/interfaces.d/eth1 for another interface:
auto eth1
iface eth1 inet static
address 192.168.1.100/24
up ip route add 10.0.0.0/8 via 192.168.1.1
Apply eth1:
ip addr flush dev eth1
ifup eth1To change eth0, add /etc/network/interfaces.d/eth0. That file overrides the default settings. e.g. use it to add an extra route.
Example /etc/network/interfaces.d/eth0:
auto eth0
iface eth0 inet dhcp
up ip route add 10.0.0.0/8 via 192.168.1.1
Apply eth0:
ip addr flush dev eth0
ifup eth0Updated about 15 hours ago